How to use the camera
-
Using of Gooseneck microphone with BA30S
![]()
The following three pictures are the Gooseneck microphone, the camera BA30S, and their connection diagrams. After the line in port of the camera i... -
Setting up a Network Video Stream
1. The first thing you are going to want to do to get your camera up and streaming on your network is to connect your camera to power, an active ne... -
SMTAV Cameras Maintenance and Troubleshooting
![]()
Camera Maintenance If the camera will not be used for a long time, please turn off the power switch. Use a soft cloth or lotion-free tissue to cle... -
How to quickly build a live broadcast system
![]()
If you want to build a live broadcast system, SMTAV is undoubtedly the best choice. We provide you with professional high-performance, low-cost aud... -
How to use WAN to control IP cameras(DDNS)
![]()
1Â Setup IP Controlled by Dynamic DNS Two dynamic DNS: Dyndns.org, 3322.org. Router Port Mapping: Take Tenda router for example, enter the Router... -
Remote control introduction
![]()
Key Description 1. Standby Key Press this button to enter standby mode. Press it again to enter normal mode. Note: Power consumption i... -
How to use OBS to connect to the RTSP video stream of the camera
![]()
The follow steps will be very similar in video production software such as vMix, Wirecast or xSplit. Open OBS and add a Scene. In the scene we can... -
Connect your camera to the network
![]()
When you are first getting setup it is helpful to connect your camera to an HDMI monitor, but you can also use the SDI output to view video from yo... -
How to set the resolution of the camera
![]()
The camera's resolution is set by a yellow dial on the back interface board of the camera. you can reference the available frame rates in your manu...
